Hi all
I have SET STATUS BAR ON and SET NOTIFY MODIFY but when I browse a table I am not seeing the table name or record numder/count in the status bar. Any ideas? I am running fully patched VFP9 under Windows 10.
Thanks
Paul Newton
I don't think SET NOTIFY MODIFY is valid ?
Try
Set Notify cursor on
Hi Alan
I hav e the same problem if I SET NOTIFY CURSOR ON in the command window.
Paul
________________________________ From: ProfoxTech profoxtech-bounces@leafe.com on behalf of Alan Bourke alanpbourke@fastmail.fm Sent: 18 September 2019 16:49 To: profoxtech@leafe.com profoxtech@leafe.com Subject: Re: Status Bar problem
Sent by an external sender ------------------------------
I don't think SET NOTIFY MODIFY is valid ?
Try
Set Notify cursor on
-- Alan Bourke alanpbourke (at) fastmail (dot) fm
[excessive quoting removed by server]
Hi Alan
It's working again now (as of this morning) and I haven't (wittingly) changed anything. I have had this happen occasionally over the years and it usually resolves itself (eventually!) Any way, thanks for your help
Paul
________________________________ From: ProfoxTech profoxtech-bounces@leafe.com on behalf of Alan Bourke alanpbourke@fastmail.fm Sent: 26 September 2019 15:53 To: profoxtech@leafe.com profoxtech@leafe.com Subject: Re: Status Bar problem
Sent by an external sender ------------------------------
Try
SET MESSAGE TO
-- Alan Bourke alanpbourke (at) fastmail (dot) fm
[excessive quoting removed by server]
-
Alan Bourke -
Paul Newton